SAPB1 – Configuration (Magic xpi 3.x)
When you place SAPB1 in a flow, Magic xpi automatically opens the Component Properties dialog box for the connector. You can enter the general configuration information in the Component Properties dialog box.
|
Note:
|
Before you use the SAPB1 connector, you should first define a SAPB1 resource in the Resource Repository. If you are going to use it as a trigger, then you also should define a SAPB1 service in the Service Repository.
If you are using SAPB1 as a step in a flow, you should first click the Component Properties dialog box's Settings tab. Here, you should select the SAPB1 resource that you previously defined in the Resource Repository. If you have not yet defined an SAPB1 resource, you cannot proceed to configure the SAPB1 connector.
|
|
Next, you should click the Component Properties dialog box's General tab,and select an interface. Click Configuration to configure SAPB1. The dialog box that opens depends on which interface you selected.
SAPB1 supports the following configuration interfaces:
|
Note:
|
-
When you use a dynamic resource, at design time the connector uses the default resource to get the required schema from SAPB1.
-
Magic xpi provides configuration file flags that can be used specifically with the SAPB1 component. Click here for more information on these SAPB1-related flags.
|
|
