Email - Trigger Configuration (Magic xpi 3.x)
The Component Configuration: Email dialog box contains the following fields:
|
|
|
|
Email Filters
|
|
From
|
Filter that indicates the email sender.
|
|
To
|
Filter that indicates the email recipients.
|
|
CC
|
Filter that indicates recipients who receive a copy of the email.
|
|
BCC
|
Filter that indicates recipients who receive a blind copy of the email. This parameter is available only when you use an IMAP server.
|
|
Subject
|
Filter that indicates the email subject.
|
|
Body
|
Filter that indicates the body of the email message.
|
|
Arguments XML Location
|
Click  to the right of the field to open the Variables List. From the list, select the variable where you want to send the arguments XML.
|
|
Operation Detail
|
|
Leave on Server
|
You can specify whether you want to store your received messages on the server. Select one of the following from the drop-down list:
If you leave this field as No, incoming messages are deleted from the server once they have been downloaded onto your computer.
|
|
Keep alive interval (minutes)
|
The amount of time in minutes that the trigger can be unresponsive before it is automatically restarted. The default value is 0, which means that the trigger can be permanently unresponsive.
|
Note:
|
You should be very careful when selecting a value for this parameter. If the chosen value is too small, a trigger may terminate before it completes a valid operation.
|
Since version: V3.2 SP2
|
|
Reconnection Policy
|
|
Reconnect every (seconds)
|
You can try to reconnect to the Email server. Enter a time interval (in seconds) that the Magic xpi Server will wait before attempting to reconnect to the email server.
|
|
Attempt to reconnect (times)
|
Enter the maximum number of attempts the Magic xpi Server makes to reconnect to the email server. For unlimited attempts enter 0.
|
To configure the Email component as a trigger, follow these steps:
-
Define Email as a service in the Service Repository. For more information, click here.
-
Place the Email component into a flow's trigger area to open the Component Properties dialog box.
-
Click the Settings tab, and select the required Service Name from the drop-down list. Click Configuration to open the Component Configuration: Email dialog box. Enter the relevant information.
-
When you have finished configuring your Email trigger, click OK to save the settings and to exit the dialog box. Alternatively, you can click Cancel to exit the dialog box without saving your settings.
